Begin your installation with a water source installation kit.  Included in the kit is anything you need to connect to a water source, including a pressure regulator and a mesh filter.

Attach the riser adapter to the installed riser then screw on the compression "T".  Push the 1/2" hose into one side of the "T".  Lay the hose out to cover the intended area, and then stake it down.  Attach the other end of the hose to the "T" and test for leaks.

Now it's time to plant your vegetation.  With proper care, your Toro drip system will provide years of service. 

Make sure and check the system regularly for leaks and damage.

Now, proceed to the "Test" at the bottom of this module.  Click on the link and answer the questions.